Photos

ZVA Slimline 2 with Splashguard, Slimline hose assembly blue

Malaysia

SD 38 Pyropal

Steam hose with steel braids for wet saturated steam up to 18 bar (210° C) and hot water up to 120° C. For cold water up to 25 bar. Minimum burst pressure 180 bar (1 : 10 safety factor

Lightweight Gravity Discharge Road Tanker Hose LG 3"

with VX 75-3" Al LG

ERV-CR

"CR" Rubber Expansion Joints - installation in sewage plant

L.P. Gas rail tanker

loading and unloading with DGC Dry Gas Couplings, LPG hose assemblies. Vehicle side: DGC-V male couplings with flange

PHD 100, airport depot

UTD hose assemblies in Ex-zone

MK-A 80 SS

MK 80 SS with active safeguard lever

RM-St 50 SSE

Female foodstuff threaded hose tail for assembling with Spannfix or Spannloc. Material: stainless steel with universally resistant PFA coating (red)

Elaflon Plus FEP 25

Adapters / couplers for vehicles fighting dangerous goods incidents:

Adapter for Rail Tanker 51/2" connection KWZ SS/Vi x VK 50 SS/Vi

ERV-R 200x175.16 ZS 4

Red Band Rubber Expansion Joint, special length 175 mm, with "ZS" limiter (tie rods with outer limitation in rubber bushings)

Solvent filling with integrated vapour recovery in the nozzle

ZVA 25 GR, UTS hose assemblies

Truck refuelling with LPG (L.P. Gas, Autogas)

ZVG 2 ACME nozzle, LPG 16 hose

Aljac Closed Circuit Sampler (CCS)

Hydrant-dispenser

Oasis FV103 Fill Valve, NC 104 Nozzle Coupler, CNG bus refuelling of small truck

Double Closing COAX Safety Break

CSB 21 DC

L.P.Gas home delivery:

LPG 38 hose assembly - Aboveground storage Tank

ZVG 2 K (Korea)

LPG nozzle for vehicle refuelling with liquefied petroleum gas (propane, butane and mixtures) up to 50 l / min. Working pressure 25 bar. Test pressure 40 bar. Burst pressure > 100 bar. Temperature range - 25° up to + 70° C, 'LT'-Type down to - 40° C.

DDC-V 25 Al; DDC-K 25

Dry Disconnect Coupling as probe/sampling unit connection at aircraft refueller

V 16-1" cr

Male ferrule hose coupling EN 14424, reusable. Slimline 16 hose, yellow.

Stainless steel couplings with PFA coating, type "...SSE"

Surface in contact with the medium additionally coated with Teflon® PFA. This type is used if stainless steel does not have a sufficient chemical resistance (i.e. for hydrochloric acid and iron-III-chloride) and polypropylene is not possible because of insufficient stability. Available in all standard sizes.