Media Library / Images

ERV-W 80.16

WHITE BAND Rubber Expansion Joint for foodstuffs, also containing oil and fat. Liner corresponds to Recommendation XXI of BfR and FDA-21CFR 177.2600. Not approved for drinking water. Temperature range (depending on medium) - 20° C up to + 90° C, temporarily up to 100° C. Electrically non-conductive.

Rail tanker unloading of petroleum based products

Plant side: FWS PP St/St composite hoses, SG 3" Sight Glasses

Terminal / gantry: 'Polypal Oil 100' and 'TW 100' hose assemblies for bottom loading of road tankers

GSD 50 Hy

Coupling seal for TW couplings, CSM green

Composite hose assemblies with 'COPSAFE' , suitable for COP systems (cross-over prevention)

electrical conductivity

Vehicle refuelling with LPG (L.P. Gas, Autogas, Propane)

GasGuard GG1 ACME nozzle

Storz Safety Couplings Type SHK

upon uncoupling, the safety dust plug first falls into holding claws, relasing an eventual pressure within the system. Only then the dust cap can be fully taken off. - increased protection for the operating personnel. Easy to use, no additional pressure release necessary, slim design, does not build up, no freezing up in the dome section.

DAC-V 65, DAC-M 65

Coupling test facility

IBC loading and unloading

MannTek DDC-M 50, FWS 50 PTFE

H2 Hydrogen

H2 25 D Hydrogen hose, SFC 25, MX 25, VC 25

MannTek DDC-M150, DDC-V150, DDC-V150 F

Elaflex hose assemblies

Hose fittings: threaded, flanged, quick couplings, Dry Disconnect Couplings

ZVA Slimline 2 GR, Coax hose assembly

Automatic nozzle with vapour recovery, flowrate up to 45 l / min.

Ship bunkering

FHD hose assemblies

Polypal Clean hose

Road tanker for heating oil delivery, HD hose assembly, ZV 500 nozzle, MK 80 Ms coupler with VB 80 P dust plug

Vehicle refuelling with LPG (L.P. Gas, Autogas)

ZVG 2 DISH nozzle, LPG 16 hose assembly, ARK 19 Safety Break

KWZ x VK 80

Rail car adapter with TW male coupling

TWD-W coupling seal

NBR white

GasGuard GG11R

The GasGuard GG11 Back-Check Valve (GG11R: with additional release screw) should be standard equipment for any LPGas road tanker operator. It is used in conjunction with LPGas bulk refueling nozzles to contain leaks at storage tank fill points. If the fill point proves to be leaking when removing the nozzle it can be left on the tank until corrective action is taken. The driver can move to the next fill point without delay.

ELAFLEX Hamburg

Assembling ERV small DN

ZVF 50 UL 91 / green

Manual aviation fuelling nozzle for overwing service. Flowrate up to 400 ltr. / min. (85 IGM – higher flowrates are possible). Size DN 50. Working pressure PN 10 (140 psi). Temperature range - 40° C up to + 55° C.

DDC Dry Disconnect Couplings for chemicals

Rail tanker loading/unloading

IBC

with CHS chemical hose assembly

Nozzles and hose assemblies for L.P. Gas (LPG, Autogas)

Functioning principle of MannTek DDC Dry Disconnect Couplings

closed - open

Hose Trolley

HTR-AF, HD 100 C NEON, HD 10 C

Elaflon PTFE 38, AMKC 38

Universal hose, Elaflex Camlock quality coupling

ELAFLEX HIBY Tanktechnik, Production Plettenberg / Germany

ZVA long term testing

GasGuard LPG nozzle GG20DN

With long connector nut to access 'hard to reach' fill points. "DN": suited for use by the general public and untrained personell (self service). Patented dual nose piece for added safety. Low lever actuation force. Gas release volume on valve closure : 1,7 cm³.